滚揉机结构简单，重要包括机架、滚桶、减速器、机械泵、链条传动、控制家用电器等一部分组成，根据下边文章内容大家详尽的掌握掌握有关滚揉机的有关知识。

The structure of rolling and kneading machine is simple, including frame, barrel, reducer, mechanical pump, chain drive, control of household appliances and other parts. According to the following article, you can master the knowledge about rolling and kneading machine in detail.

1、每一次滚揉机工作上结束后，打开机械泵油气分离器离心水泵水泵底阀电源总开关，排空储水，清除机械泵吸入物，清除机械泵油气分离器，保证 真空电磁阀道顺畅。

1. At the end of each rolling and kneading machine operation, turn on the main power switch of the mechanical pump oil-gas separator centrifugal pump bottom valve, empty the water storage, remove the mechanical pump suction, remove the mechanical pump oil-gas separator, and ensure the smooth vacuum solenoid valve passage.

2、机械泵应每个月一次停泵检查油的空气污染情况，倘若机械泵外干已被空气污染，则应该马上换机油。换机油之前泵尽量载满正转15分钟，让油升温后停泵旋扩大开放油塞将污油排空，用一些新油清除或用食用油高压清洗机后导入新油。可参照《滚揉机真空泵常见故障与维修方法》。

2. The mechanical pump should be stopped once a month to check the air pollution of the oil. If the outside of the mechanical pump has been polluted by the air, the oil should be changed immediately. Before changing the engine oil, the pump should be fully loaded and run forward for 15 minutes as far as possible. After the oil is heated up, stop the pump and open the oil plug to drain the dirty oil. Remove the dirty oil with some new oil or use edible oil to clean the machine under high pressure and then introduce new oil. Refer to the "rolling machine vacuum pump common faults and maintenance methods.".

3、经常检查减速器剩余油，如发现剩余油低于油位表高度1/2时要马上添加30号润滑油脂。

3. Check the remaining oil of the reducer frequently. If the remaining oil is less than 1 / 2 of the height of the oil level gauge, add No. 30 lubricating grease immediately.

4、滚揉机家用电器控制箱要牢固接地系统，确保用电安全。

4. The control box of household appliances of rolling and kneading machine should be firmly grounded to ensure the safety of electricity.